This is what I have:
Protocols we want to be serving:
imap imaps pop3 pop3s
protocols = imap pop3
IP or host address where to listen in for connections. It's not currently
possible to specify multiple addresses. "*" listens in all IPv4
interfaces.
"[::]" listens in all IPv6 interfaces, but may also listen in all IPv4
interfaces depending on the operating system. You can specify ports with
"host:port".
imap_listen = * pop3_listen = *
When I run NMAP this is what I get back:
PORT STATE SERVICE 22/tcp open ssh 111/tcp open rpcbind 143/tcp open imap
Now the only time I need to uncomment something in the conf file is if I change it from the default settings, correct? Do I need to have anything setup in my xinetd.d directory?
Timo Sirainen wrote:
On Thu, 2004-07-22 at 16:09, Tom Ray [Lists] wrote:
That was already configured and it still refuses to respond on port 110. I keep getting connection refused errors, when I telnet or use a mail client to access port 110....
protocols = pop3 is the only thing that should be needed. Do you see any pop3-login processes? Are you sure the protocols-line wasn't just commented out? :)